The installation process for the Plastimo Manual Bilge Pump 925 OEM Grey Handle/Without By-Pass will depend on the specific boat and bilge configuration. However, here are some general steps that can be followed for installation:
- Choose a location: The pump should be installed in a convenient location that is easily accessible in case of an emergency. It should be mounted at the lowest point of the bilge.
- Mark the location: Use a pencil to mark the location where the pump will be installed.
- Drill holes: Use a drill to create holes in the marked location. The size of the holes should be slightly smaller than the mounting screws that came with the pump.
- Mount the pump: Place the pump into position and secure it with the mounting screws. Use a screwdriver to tighten the screws securely.
- Connect hoses: Connect the intake and discharge hoses to the pump. Ensure that they are securely fastened with hose clamps.
- Test the pump: After installation, test the pump to ensure that it is working correctly. Manually operate the pump lever a few times to check for proper suction and discharge of water.
- Secure loose wires: If necessary, secure any loose wires and tuck them away to prevent damage.
It’s important to follow the manufacturer’s instructions and safety guidelines for installation to ensure that the pump is installed correctly and functions properly. If you are unsure about any aspect of the installation process, it’s best to consult a professional boat mechanic or technician.
There are no reviews yet.